15.02.2015, 12:21
Hi,
Ich habe ein Gigabyte board und möchte wake on LAN aktivieren. Habe ich eine Chance?
Ich habe ein Gigabyte board und möchte wake on LAN aktivieren. Habe ich eine Chance?
Code:
Created at pci.318]
UDI: /org/freedesktop/Hal/devices/pci_1969_1091
Unique ID: rBUF.DunhqfG45E5
Parent ID: QSNP.xpwxxKVOE11
SysFS ID: /devices/pci0000:00/0000:00:1c.4/0000:03:00.0
SysFS BusID: 0000:03:00.0
Hardware Class: network
Model: "Attansic Ethernet controller"
Vendor: pci 0x1969 "Attansic Technology Corp."
Device: pci 0x1091
SubVendor: pci 0x1458 "Giga-byte Technology"
SubDevice: pci 0xe000
Revision: 0x10
Driver: "alx"
Driver Modules: "alx"
Device File: eth0
Memory Range: 0xf7100000-0xf713ffff (rw,non-prefetchable)
I/O Ports: 0xd000-0xdfff (rw)
IRQ: 44 (55516 events)
HW Address: 90:2b:34:a6:dd:f9
Link detected: yes
Module Alias: "pci:v00001969d00001091sv00001458sd0000E000bc02sc00i00"
Driver Info #0:
Driver Status: alx is active
Driver Activation Cmd: "modprobe alx"
Config Status: cfg=new, avail=yes, need=no, active=unknown
Attached to: #16 (PCI bridge)
#S1: Gigabyte GA-H77M-D3H, Intel 1610 Celeron, 4GB RAM, Cine S2 6.5 + Duoflex S4, NVIDIA GT 630, IBM SSD 240GB, Atric IR Einschalter, DVD-Brenner mit easyvdr 3 oder MLD5
#S2 (offline) POV MB-D510-MATX, 2GB, GT 220, TT 1600
#C1: RPi3 MLD5.1
#S2 (offline) POV MB-D510-MATX, 2GB, GT 220, TT 1600
#C1: RPi3 MLD5.1