[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[openrisc] using GDB for remote debugging.

To: openrisc@opencores.org
Subject: [openrisc] using GDB for remote debugging.
From: maunal moren <maunal02@yahoo.com>
Date: Mon, 13 May 2002 23:41:29 -0700 (PDT)
Reply-To: openrisc@opencores.org
Sender: owner-openrisc@opencores.org

Hi,

I'm trying to use the GNU tool chain for OR1200.

Could anyone tell me how to use GDB for remote debugging?

The uncleared points to me are as follows:

1. How can I connect the host to target system? (Can I use the
SOC/OpenRISC development interface? )

2. Is there any debugging stub to connect target system through serial
cable?

3. How can I connect GDB to or32-rtems-sim?

Thank you in advance

/maunal

Do You Yahoo!?
LAUNCH - Your Yahoo! Music Experience

Follow-Ups:
- Re: [openrisc] using GDB for remote debugging.
  - From: "Marko Mlinar" <markom@opencores.org>

Prev by Date: Re: Re: Re: [openrisc] or1200 sim
Next by Date: [openrisc] OR chip? Free .35 CMOS Foundry Run (fwd)
Prev by thread: Re: [openrisc] OR chip? Free .35 CMOS Foundry Run (fwd)
Next by thread: Re: [openrisc] using GDB for remote debugging.
Index(es):
- Date
- Thread