[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[oc] RS232 VHDL help



I'm currently working on the Vhdl for Xilinx's FPGA.  The output is 
characters which will be sent to RS232 port.  The chip's frequency is
11.05 Mhz. Since it's (9600,8,N,1),  I tried to use a counter that
count to 1151(11.05MHz/9600 = 1151) and then output a 'high' in order
to generate 9600 baud rate.  However, what I got is always junks.
In vhdl, I use Wait on clk9600 = '1' to send one bit at a time and I
used for ten times because its total is ten bits(start +data+ stop
bit). Is this the correct way to do this? And also, there are only
(transmit,receive and ground pins going through rs232 com1 port)

I need some help as soon as possible.  Any help is appreciated.

Could anybody give me some suggestions to code this program.
--
To unsubscribe from cores mailing list please visit http://www.opencores.org/mailinglists.shtml